Homepage » Minecraft Mods » Automatic Infinite Elytra Mod (1.21.1, 1.20.1) – Infinite Fly Glitch

Automatic Infinite Elytra Mod (1.21.1, 1.20.1) – Infinite Fly Glitch

56 views ❘ 1 week ago ❘ Author: AdyTech99 ❘ Available for: Fabric

Minecraft’s elytras have a glitch that allows players to fly infinitely. By flying up and down at certain angles at certain intervals, the player will be able to travel very long distances without using any fireworks. If these up/down angles are perfect and are performed at precise intervals, the player will be able to travel an infinite distance without using any fireworks. Automatic Infinite Elytra Mod (1.21.1, 1.20.1) allows you to perform this infinite fly glitch using just a keybind. More details as listed by the developer are given below.

Features:

How to use Automatic Mode?

Step 1: You will need to be flying in the air using an Elytra.
Step 2: Gain a bit of height; 100 blocks above ground level is recommended.
Step 3: Press the keybind (default ‘right alt’) to toggle Automatic Flight on.
Step 4: Enjoy!

Collision Detection Utility

The Collision Detection Utility will automatically activate when in Automatic flight mode. If an obstacle appears in front of the player, the Utility will:
Deactivate automatic flight
Turn the player 180° in order to avoid the obstacle
Print a warning in chat

How to use Autopilot?

Step 1: You will need to be flying in the air with Automatic Flight Mode enabled (see above).
Step 2: Enter the command /setDestination where x z are your destination coordinates.
Step 3: Enjoy!
Step 4: The mod will automatically land if ‘Perform Automatic Landing’ is enabled in the Config.
Step 5: To unset your current destination, use /removeDestination. To reuse your previously set destination, enter /setDestination without any further coordinates.

Flight Analytics

Each autopilot (where destination is set with /setDestination) flight’s stats are recorded and stored on a per-flight basis. When a new auto piloted flight starts, the old data will be cleared.

The analytics includes the following data:

Distance
Time
Average speed
Elytra durability used
You can see the stats by using the command /flightanalytics.
Alternatively, you can enable “Automatically print analytics” in the config.
If you do not wish for the analytics data to be recorded, you can disable it entirely in the config.

Explore Area

This feature explores and generates all chunks within the boundaries of the rectangle set by the coordinates x1, z1, x2, z2
where x1 and z1 are the bottom-left coords of the rectangular area you want to explore
and x2 and z2 are the top-right coords of the rectangular area you want to explore.
To use, run the command /exploreArea